Is there any interest?

[Longhairfreak]

I have a complete right down to the clutches Engine Tech 900 based on the Polaris 800. Comes with Jaws 1404 pipes. Even has the 97 700 ignition with a new stator. Was thinking of selling if there is interest. 180 hp and 116 ft lbs torque. Needs pistons or crank haven't taken apart yet.

 

[Longhairfreak]

Just had a look needs 1 piston.

 

[pipeliner72]

No thanks I prefer to buy my boat anchors at cabelas!

 

[Bnorth]

will it bolt into my ascender chassis?

 

[kanedog]

How much does a broken piston motor go for these days?

 

[Longhairfreak]

How much does a broken piston motor go for these days?

$2000

 

[Longhairfreak]

will it bolt into my ascender chassis?

It would but it would be a lot of work.

 

[Longhairfreak]

No thanks I prefer to buy my boat anchors at cabelas!

I'd like to see your ride.

 

[Bnorth]

It would but it would be a lot of work.

I'm interested in bolt in only

 

[Chrisco]

That the same engine I spanked with my 900 cat twin in my Polaris edge back in 2000 ?

 

[Longhairfreak]

That the same engine I spanked with my 900 cat twin in my Polaris edge back in 2000 ?

Not a phuking chance. This was a 2006 build. I didn't know that you had a Polaris Edge in 2000. Were you some kind of Polaris tester for the up and coming? Did you have any involvement in the 900 Polaris? How many 1160s did your Polaris big bore spank? Were you a belt drive guru for Polaris? Did you have any involvement with Polaris on gluing sleds together? Were you an integral part of the Polaris track testing?

 

[banditpowdercoat]

I'm interested in a cool coffee table.

 

[Longhairfreak]

I'm interested in a cool coffee table.

Talk to Chrisco.

 

[Longhairfreak]

If Chrisco had an Edge in 2000 he must have been a Polaris engineer for one of the worst sleds Polaris built.

 

[deaner]

I am very interested. Would this bolt into an rx1 chassis without too much modification?

 

[banditpowdercoat]

Talk to Chrisco.

Has to be turn key... lol

 

[kanedog]

Is this still available?

 

[Chrisco]

Ur right sorry my mistake it was my Gen II first and then my Edge after that. That 1160 billet belt blower could never hold a belt for more than 5 minuets.

 

[Longhairfreak]

Ur right sorry my mistake it was my Gen II first and then my Edge after that. That 1160 billet belt blower could never hold a belt for more than 5 minuets.

Actually my 1160 was the first 1160 to stop blowing belts.

 

[Longhairfreak]

Is this still available?

It is.