d2therick
Member
just wondering how to weld the crank on a 1m. does anyone have any pics tip and tricks? also is there anything else I should do while I have the bottom end split?
how to weld crank? aslo what else should i do while its split?
- Thread starter d2therick
- Start date
Vance Matheson
Active VIP Member
What's a 1m
Sent from my SGH-I747M using Tapatalk
Sent from my SGH-I747M using Tapatalk
ippielb
Active VIP Member
- Joined
- Mar 4, 2011
- Messages
- 1,967
- Reaction score
- 3,605
- Location
- SE Saskatchewan
- Website
- www.youtube.com
you get the crank true as close as you can, and then weld the pins to the webs. Then after welding check for true again, and hammer it out back to zero or as close as you can get it. But before you do that, replace the inner crank bearings/seals, once you weld it, you wont be able to split the crank unless you go to town on it. Just trying to true the crank can be a headache in itself if you aren't properly set up.
Last edited:
DRD
Active VIP Member
Not to sound like a dick but if you have to ask you would be best to send it out where they have the jigs and expertise.
BDF#900
Active VIP Member
if your doing an oil injection delete there is a spot you need to drill a hole in the cases to allow lube to drip on the gear for the water pump.
Similar threads
