How to change stock belly plastic

[shiftrus]

Hey guys ,

took my new summit sp out today and was having a blast ditch banging when the sled decided to ride without me on it. I was side hulling and stopped for a second to reposition myself and then gave it some gas and it went into wot and stuck there. It bucked me off the sled as it jumped the hwy and went full out to a patch of young saplings and willows. Where it drove through about 10 meters of brush and finally stopped on its side and idled down and waited for me to walk my hurting ass to shut it off. The only damage besides a few scratches to the plastics would be one broken ski hoop and broke the belly pan right by the bumper. So I came out lucky there. So I picked up a new pan and hoop and would like some pointers on changing the pan out. And no the dess wasn't attached to me but will be from now on. And if it decides to do it again I'm taking it in to get looked at. Sorry for the short story guys.

 

[towerrigger]

Pretty straight forward. Hood has to come off, 4 torx screws T 20? Small flat head screw driver inserted just above gauge to pop cluster out. There's 2 connectors behind gauge. One for cluster other tucked up on right side. There's a small hose on right side that goes to ECM. Unplug from ECM. Left side is upper air box tube. Unhook sensor, grey with locking tabs on both sides, tube twists to unlock. Slide hood off. If your replacing bottom nose cone you will need 4 large head rivets for front bumper. There is also two rivets above shocks that hold bottom pan in place.