I've been looking at the hoods of a lot of these Summits and comparing them to mine and mine seems to not be fully inline like the rest of that i've seen, the very front is not aligning with the bottom front of the sled. Granted it's not that far off to cause any kind of issue and appears to be esthetic but if I can fix it I'd like too. I've looked the sled over and everything is straight and in good condition so that's not the issue here.
Hood alignment
- Thread starter AkNomad
- Start date
maxwell
Active VIP Member
most likely something to do with that front bumper pulling things out of shape
- Thread starter
- #4
No, I've taken it apart a dozen times to see if I could straighten it but I haven't seen anything that would cause it not too line up.
- Thread starter
- #5
Hmmmm, you might be on to something, i'll have to check that and see.
tmo1620
Active VIP Member
Same thing happened to my buddies 19 g4 850, he put on a bm fab bumper and it did the same thing, he did some “adjusting “ and lined it up better, not exactly sure what though lol
maxwell
Active VIP Member
probably involved a grinder, pry bar and hammer lol
GreyGhost
Active VIP Member
Agreed more then likely they didn’t put the holes that mount to the lower grille and frame in the correct spots. Then pushing the lower grille out farther. I’ve just re drilled the two back holes and trimmed it to pull it back in. It’s pretty hard to misalign those hoods
tmo1620
Active VIP Member
Similar threads
