Enclosed Trailer - Tandem Towing

nast70

Active VIP Member
Joined
Jan 14, 2010
Messages
837
Reaction score
2,134
Location
edmonton
Considering an enclosed trailer for overnight hunting and getting the bikes to destinations. I'm debating a SA vs TA with brakes, leaning towards the TA for the cargo capacity.
If i tandem tow the cargo trailer, will the cargo trailer brakes engage the same time as the 5th wheel? Wondering how exactly that would work?
 

papajake

Active VIP Member
Joined
Dec 5, 2006
Messages
2,942
Reaction score
5,885
Location
Didsbury, Alberta
I would check with Alberta transportation before going ahead pulling an enclosed behind a 5th wheel trailer I have never wired a plug for brakes on a hitch on the rear of a trailer but the trailer must have a brake away installed
 

MP Kid

Active VIP Member
Joined
Dec 20, 2010
Messages
3,148
Reaction score
4,347
Location
East of Calgary
It can be done… but there’s quite a few things to consider other than just the wiring:

Max overall length cannot exceed 65’ in AB.
Is your truck rated for the total payload/towing capacity.
Is your 5th wheel frame and axles stout enough to handle the extra load placed on it due to the cargo trailer.
Where do you plan to go… BC is a no go with this set up for a personal vehicle.
 

acesup800

Active VIP Member
Joined
Nov 29, 2008
Messages
1,462
Reaction score
2,652
Location
BC
Easy to do if the cargo trailer has hydraulic brakes or doesn't require brakes. I have done this a lot. Just need to beef up the rear hitch on the 5th wheel to ensure solid mount to the frame. I would push towards the single axle to avoid the brake situation unless you plan on switching out the electric to hydraulic which isn't that difficult to do.
 

blastoff

Active VIP Member
Joined
Feb 20, 2007
Messages
2,478
Reaction score
969
Location
Alberta
I just seen this set up today, a guy with a diesel pulling about a 34 foot 5th wheel and a 7X14 enclosed with electric brakes on enclosed, I dont know if its legal but it looked ok
 

Mike270412

Golden Boy
Joined
Apr 29, 2008
Messages
29,401
Reaction score
48,105
Location
GBCA
It can be done… but there’s quite a few things to consider other than just the wiring:

Max overall length cannot exceed 65’ in AB.
Is your truck rated for the total payload/towing capacity.
Is your 5th wheel frame and axles stout enough to handle the extra load placed on it due to the cargo trailer.
Where do you plan to go… BC is a no go with this set up for a personal vehicle.
It's actually ok in BC if you have a big enough truck pulling it.
 

cdnredneck_t3

Active VIP Member
Joined
Feb 17, 2012
Messages
692
Reaction score
1,597
Location
East of the Rockies and west of the rest.

Lightningmike

Active VIP Member
Joined
Jan 6, 2012
Messages
26,387
Reaction score
19,109
Location
Lloydminster Sk.
If trailer and load exceed 10,000lbs or 4500 kgs you require a class 1. I think alberta is same . That's total combined weight of trailer(s) and load. Of course the truck has to have a GVWR to handle all as well
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,122
Reaction score
56,170
Location
Leduc
This will work on the 2 nd trailer
IMG_4763.png
 

acesup800

Active VIP Member
Joined
Nov 29, 2008
Messages
1,462
Reaction score
2,652
Location
BC

ABMax24

Active VIP Member
Joined
Sep 10, 2013
Messages
4,885
Reaction score
14,179
Location
Grande Prairie, Alberta, Canada
Ha, arff beat me to it.

I'd try something like this. By my understanding it uses power from the brake and the brake light signal to trigger the trailer brakes. This way your first trailer is connected to the truck brake controller and this one is controlled via Bluetooth on your phone.


Check the wiring schematic to make sure this is correct, but I think it would do the trick.
 

acesup800

Active VIP Member
Joined
Nov 29, 2008
Messages
1,462
Reaction score
2,652
Location
BC
If trailer and load exceed 10,000lbs or 4500 kgs you require a class 1. I think alberta is same . That's total combined weight of trailer(s) and load. Of course the truck has to have a GVWR to handle all as well
You don't require a class 1 to tow over 10,000 lbs. If its a rec trailer, you only need a house trailer endorsement (write a test), but any other trailer over 10,000 lbs, you need a heavy trailer endorsement which includes a test and an actual drivers test including getting tested on a vehicle/trailer walk around. I did this this summer to pull a 13,000 lb boat and then a guy has it. You have to do a medical every 3 years too for the heavy endorsement. And no air brakes. This only applies to BC licenses, as long as you are legal in your province, you are good here.
 

Absledder

Active VIP Member
Joined
Oct 29, 2013
Messages
758
Reaction score
681
Location
bonnyville
If trailer and load exceed 10,000lbs or 4500 kgs you require a class 1. I think alberta is same . That's total combined weight of trailer(s) and load. Of course the truck has to have a GVWR to handle all as well
Can anyone from AB confirm this? I was under the impression (and so far my googling has shown) that a class 5 was good for anything as long as the tow vehicle only had 2 axles and the trailer had electric brakes? Air brake endorsement required if the truck has air brakes.
 

adamg

Active VIP Member
Joined
Mar 8, 2011
Messages
3,474
Reaction score
4,691
Location
S'toon,SK
Can anyone from AB confirm this? I was under the impression (and so far my googling has shown) that a class 5 was good for anything as long as the tow vehicle only had 2 axles and the trailer had electric brakes? Air brake endorsement required if the truck has air brakes.
In Sask, Class 5 can't tow a trailer over 10k lbs. Although it is allowed if you pass the 'heavy trailer' endorsement test.
 

nast70

Active VIP Member
Joined
Jan 14, 2010
Messages
837
Reaction score
2,134
Location
edmonton
That's kinda what i was hoping for. I was thinking a bit simpler, maybe something that would amplify the brakes signal to the second trailer making them brake a touch harder than the main trailer to help keep things straight, especially in sketchy spots.
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,122
Reaction score
56,170
Location
Leduc
Ha, arff beat me to it.

I'd try something like this. By my understanding it uses power from the brake and the brake light signal to trigger the trailer brakes. This way your first trailer is connected to the truck brake controller and this one is controlled via Bluetooth on your phone.


Check the wiring schematic to make sure this is correct, but I think it would do the trick.
I talked to a couple people using this. They tow a trailer behind a 5th wheel camper. They claim it works great
 

Trashy

Super Moderator
Moderator
Joined
Nov 16, 2008
Messages
132,646
Reaction score
104,981
Location
Fort Macleod
Bringing this back up
Just got a smaller 5th wheel camper and was thinking of adding a 2nd trailer behind.
Had the discussion yesterday afternoon during happy hour. And one of the guys said, to run new wiring under the 5th and tie it into the junction box located in the 5th wheel hitch. Once tied in, the truck built in trailer brakes, should be able to control both trailer(s) braking at the same time, without additional hardware.
Has anyone heard or have tried this? It does kind of make sense......
 

ABMax24

Active VIP Member
Joined
Sep 10, 2013
Messages
4,885
Reaction score
14,179
Location
Grande Prairie, Alberta, Canada
Bringing this back up
Just got a smaller 5th wheel camper and was thinking of adding a 2nd trailer behind.
Had the discussion yesterday afternoon during happy hour. And one of the guys said, to run new wiring under the 5th and tie it into the junction box located in the 5th wheel hitch. Once tied in, the truck built in trailer brakes, should be able to control both trailer(s) braking at the same time, without additional hardware.
Has anyone heard or have tried this? It does kind of make sense......

Generally you're going to need a second brake controller of some sort, as it's highly unlikely both trailer will brake with the same effort. For example, your cargo trailer could be locking up the brakes and the fifth wheel might not even be braking yet.
 

moyiesledhead

Active VIP Member
Joined
Oct 12, 2008
Messages
5,455
Reaction score
10,890
Location
Moyie B.C.
You don't require a class 1 to tow over 10,000 lbs. If its a rec trailer, you only need a house trailer endorsement (write a test), but any other trailer over 10,000 lbs, you need a heavy trailer endorsement which includes a test and an actual drivers test including getting tested on a vehicle/trailer walk around. I did this this summer to pull a 13,000 lb boat and then a guy has it. You have to do a medical every 3 years too for the heavy endorsement. And no air brakes. This only applies to BC licenses, as long as you are legal in your province, you are good here.
House trailer endorsement in BC requires both a written test and a road test.

 
Top Bottom