ECU Error code 05

[Eldereldo]

2014 M8000. I did a bunch of work on the sled this summer which involved removing the hood. Put it all back together and fired it up and am getting this warning about the air temperature sensor. So I pulled it and tested the resistance and it seems to be in spec, what else should I be checking? What voltage should there be going to the sensor? Any fuse associated with this, I can't see one in the manul, and all of the fuses look fine in any case.

 

[Cat401]

Code Trouble
2 Failure in injector(s).
4 Open or short circuit in barometric
pressure sensor.
5 Open or short circuit in intake air temperature
sensor.
6 Open or short circuit in water temperature
sensor.
7 Open or short circuit in throttle position
sensor.
12 Failure in ignition coil(s).
16 Incorrect adjustment/failure in APV
cable.
17 Failure in exhaust temperature sensor.
18 Failure in servomotor.
21 Open or short circuit in/or loose knock
sensor.
OCTN Low octane gasoline.

 

[Cat401]

did you recently wash it?

 

[Eldereldo]

Nope.

 

[Dragon4x4]

Check the wiring to the sensor, harness might be pinched in one spot from a zip tie.. My thumb heater failed at the end of last season due to the zip tie on the handle bar.

 

[Eldereldo]

What Is the voltage to the sensor supposed to be?

 

[Eldereldo]

Well turned out to be a loose connection so all good now.