Digatron

[theunit1]

Hey guys just looking for some answers , I have a M1000 with piros on my y-pipe and i cant keep the things in! i go half day sometimes less and i blow one out or both ,then i need to cool the motor loosen them off and slide back in, just wondering if anyone has any tips or ideas on how to keep them in? High temp loctite maybe??

 

[1100]

Are you running the weld in probe fittings?

 

[theunit1]

No just the clamp style! But its like the pressure fitting gets warm and then slides out!

 

[magnet]

sounds like not tight enough? i have never had an issue with mine so not sure what else it could be.

 

[1100]

Im no help to you. Always have ran the weld ins and have never had an issue.

 

[dangerm1000]

when u tighten the fittings can u twist the probes around after or are they tight in the fitting because since the ferruls in the fitting are softer than the probe material they will need to be tightened fairly tight or they will not bite and when they warm up they will pop out. I had to mark mine and pull them out to hold good back up on clamp while i tightened fitting hope this helps.