Can this be re-bent?

[Carrots]

With a heat gun and sledge hammer and crowbar? Lol and still be rideable for tomorrow?

 

[Carrots]

Or does anyone have a extra set of rails kicking around in valemount?

 

[snopro]

HaHa check with Maxwell. Maybe he found 2 sets.

 

[towerrigger]

That looks like it bent in the spot the free ride has the rail reinforcements. I'll be headed down to dealer tomorrow to pick some up after seeing this. Care to share the story?

 

[maxwell]

Hey my 163 looks the same. Too bad it's a 154 or you could have my slightly less bent one LOL.

I'd bend it back and bolt Oma peice of angle iron or something and keep riding. But it's such a pita to remove it to fix it


Sent from my iPhone using Tapatalk -

 

[Carrots]

Hey my 163 looks the same. Too bad it's a 154 or you could have my slightly less bent one LOL.

I'd bend it back and bolt Oma peice of angle iron or something and keep riding. But it's such a pita to remove it to fix it


Sent from my iPhone using Tapatalk -

I could take that 163 rail off your hands and just take a Zip disk to shorten it up lol

 

[Trashy]

It can be rebent

 

[snopro]

Try and re create the event backwards Bugs and you should be good to go for tomorrow.

 

[Carrots]

That looks like it bent in the spot the free ride has the rail reinforcements. I'll be headed down to dealer tomorrow to pick some up after seeing this. Care to share the story?

Story is there was a rock where there shouldn't of been a rock lol

 

[towerrigger]

It's just a matter of time before them rocks get ya!

 

[zeebs]

Better than re-bending bugs, grab the polish and rag..............that'll buff out! chitty deal man. Good way to ruin a good trip.

Chances are good I should be working!

 

[moyiesledhead]

It can be rebent

Wouldn't it have to be straightened first?

 

[powpowpowpow]

That looks like it bent in the spot the free ride has the rail reinforcements. I'll be headed down to dealer tomorrow to pick some up after seeing this. Care to share the story?

not really,had rail braces on and did a little bump hit and it bent after the brace where the rail starts to tip up....there needs to be a brace that goes to the back idlers and is made to fit the tip up...stock rails are cheesy thin

 

[Destroyer]

PUll them out straighten them with a press and get a local welding shop to fab up some stiffeners.

 

[dogsmack]

Wouldn't it have to be straightened first?

nothing better then a awesome grammer police raid. lol

 

[ferniesnow]

nothing better then a awesome grammer police raid. lol

Oh, oh, oh..........

How about "nothing better than an awesome grammar police raid"......just sort of thought it fit the scenario