C3 belt drive with Boost-it turbo?

[moto5151]

Anyone running a C3 belt drive on their pro with a Boost-it turbo setup? Having some fitment issues. Not sure if it will fit. Any help would be greatly appreciated.

 

[kakwa climber]

I do on my 11

 

[+SLEDWRECKS+]

I did on my '11 as well.

 

[moto5151]

Thanks for the pictures, but I have a different setup. Mine is the replacement belt drive. Yours is the belt conversion. The mount is much bigger.

 

[big_vernster]

Did this on my 13 and a guy at absolute power and performance hacked my turbo bracket out to make the C3 fit. The pulleys never aligned properly and the belt would ride up and tear. Tried repeatedly to fix it with spacers and washers with no luck. Took it back to boost-it and replaced factory pulley. Would never go back to Absolute Power and Performance. Cost me around $2000 total. Apparently TKI makes a tensioning belt set upthat will work on the Boost it setup without mods and is supposed to workgreat.

 

[moto5151]

I spent some time and have managed to get it to fit. I bolted the belt drive idler in, then reworked the turbo mount bracket. That way the idler is correctly mounted and square.

 

[ABMax24]

Any pics?

What ratio did you go with?

 

[moto5151]

Sorry, no pics. But I went with 2.52 ratio, and 7 tooth drivers. Having issues with skid alignment though. Front skid is off to the right about 1/4". Track is center in tunnel, drivers are aligned with the track, and the rear wheels are aligned in the track. Not sure what's going on.