Brake Clean

BC Sno-Ghost

Active VIP Member
Joined
Feb 15, 2009
Messages
1,238
Reaction score
444
Location
Kelowna
yes this is common knowledge, but if you think about it the aluminum wold have to be hot and expanded in order to "absorb" anything. Also you are cleaning a machined surface that has only microscopic pores that are filled with rubber. which is worse the rubber or the solvent to your next belt?

Good points!:beer:
 

Modman

Active VIP Member
Joined
Mar 13, 2008
Messages
6,040
Reaction score
8,523
Location
Castlegar
You can use anything that does not leave a residue. Unless you are cleaning your clutches when they are over 300 celcius (at which temperature they would be untouchable), the metal pores are not going to "soak" up any cleaners.

Don't forget to clean the belt, this is often overlooked and often where the contaminants actually come from, not from the cleaner residue left in the pores of the metal.
 

Bernoff

Active VIP Member
Joined
Mar 11, 2010
Messages
1,386
Reaction score
1,338
Location
Edmonton
Sorry Modman but never heard of that before. Wife won't let me put it in the tub with her. So how else should I clean the belt?
 

Pistonbroke

Active VIP Member
Joined
Oct 10, 2007
Messages
3,370
Reaction score
11,221
Location
Cockring, AB
Put it the dish sink with hot water and a touch of soap and scrub it with a brush:d rinse it off and giver' :)

Every belt should be done like this, especially brand new ones! They are still covered with a greasy mold release compound from the factory.
 

Bernoff

Active VIP Member
Joined
Mar 11, 2010
Messages
1,386
Reaction score
1,338
Location
Edmonton
I was at Canadian Tire and could not find the scotch brite pads in the sandpaper isle or the autobody. Is it a special pad only found in automotive stores like NAPA?
 

skinnybitch

Active VIP Member
Joined
Nov 15, 2006
Messages
1,670
Reaction score
1,898
Location
HazzardCounty
You will more than likely find them in with the household cleaning supplies and they look like this:
 

Polarblu

Active VIP Member
Joined
Feb 14, 2010
Messages
998
Reaction score
319
Location
British Columbia
I was at Canadian Tire and could not find the scotch brite pads in the sandpaper isle or the autobody. Is it a special pad only found in automotive stores like NAPA?
Industrial stores that sell bolts and welding supplies. Greggs Distributors is the easiest.
 

ChillySeven

Active VIP Member
Joined
Jul 24, 2010
Messages
203
Reaction score
233
Location
Alberta
I think some of you guys are reading into this issue too much. Brake clean and a red scotch brite pad afterwards is all I would do.

In 05 I was told to do this exact same thing by a dealer and I have never had a problem.
 
Top Bottom