boost bottle

[andrewm93]

I bought a boost bottle and they said it shouldn't need any adjusting just install it and go, but when i put it on it bogs and sputters so i took it off and plugged the holes and it runs fine. Does anyone have any experience with these is there any adjustments that need made to make them work?
Thx

 

[youngpolarisguy]

You will have to adjust your pilot screw. mine is at around one turn try that. The boost bottle leans them out I beleive. Also go to slp's website and follow their install.Polaris - SLP Boost Bottle - Starting Line Products

 

[heavy d]

You will have to adjust your pilot screw. mine is at around one turn try that. The boost bottle leans them out I beleive. Also go to slp's website and follow their install.Polaris - SLP Boost Bottle - Starting Line Products

x2.. you def need to adjust pilot

 

[andrewm93]

thanks guys the instructions that came with it completely leave that part out i will give it a shot and see what happens.

 

[Rockwerx]

Keep an eye on your carb boots after you install a boost bottle. Even though the boost bottle hardley weighs anything, over time they can break the tubes off of the carb boot and can cause engine problems. I had one on my 800 and after a 100 mile mountain run in Golden I was inspecting my sled and both tubes were broken and leaking air. I was lucky to have spares and was able to finish a long weekend riding but I never ran the boost bottle again. Just a heads up, I am not saying to not run one.
Good luck with your sled!