Green1trailguy
New member
I recently purchased a BIG GUN full exhaust kit and power programmer for my 2014 Polaris Sportsman 570. The power programmer was easy to install, and the exhaust looked to be built well. That's where the good experience ended. The fitment was terrible! The header pipe binds on the cylinder head and the exhaust lined up with the stock mounts very poorly. After taking it for a test drive, power was noticeably increased as well as noise. This pipe is LOUD. Unfortunately, the muffler does not clear the torsion suspension and if left as is, the suspension was going to put a big hole in the side of my new muffler. The solution? I took the muffler to an aluminum welder and cut the old mounts off, rotated the muffler 90 degrees and welded one tab to fit one accessible muffler mount. After all this, the suspension still barely rubs the muffler :$
When I contacted BIG GUN, they offered no apology an stated that there must be a difference between Canadian and American models and have not responded to my emails since.
If you insist on BIG GUN, I recommend purchasing a BIG GUN exhaust through a local dealer so that it can be easily returned in the likey even that it does not fit.
When I contacted BIG GUN, they offered no apology an stated that there must be a difference between Canadian and American models and have not responded to my emails since.
If you insist on BIG GUN, I recommend purchasing a BIG GUN exhaust through a local dealer so that it can be easily returned in the likey even that it does not fit.