Axys 800 Reliability

[JustinMan43]

Glad to hear yours is holding up well! Mine is in the shop right now getting a full long block put in. Mine fouled a couple plugs, and started taking quite a few pulls to start (with throttle) but once running on both cylinders didn’t sound out of the ordinary and i didn’t notice any lose of power. Did a compression test and showed 120mag/45pto. Took it in for a tear down and found pto side bottom piston ring broke and destroyed the engine. Head, block, crank bearings and noticeable damage to crank. 2200km on it. Thank god for warranty

Think this will ball hone out? Haha new long block picked up and ready to be broken in !

 

[gdhillon]

I have fouled a few plugs on the 800’s. But always keep a spare set.

Usually after I do some slow riding following my kids around.

I think they are pretty rich in the low end. Maybe I should check my TPS but I’d rather be rich than lean.

What are signs of fouled plugs?

Yesterday my sled kept cutting out at WOT. Original plugs (350ish miles)

 

[Tchetek]

What are signs of fouled plugs?

Yesterday my sled kept cutting out at WOT. Original plugs (350ish miles)

Sled is only running one one cylinder. Hard to start. Idle around 1200 rpm and max out a little over 6 thousand.

Then pull the plug wires off one at a time to figure out which side is fawked. If you pull one wire and the sled dies it’s the other one.

 

[Tchetek]

What are signs of fouled plugs?

Yesterday my sled kept cutting out at WOT. Original plugs (350ish miles)

You really haven’t had good luck hey?

 

[gdhillon]

You really haven’t had good luck hey?

Lol no not really.

Considering last season I was on a pro chassis turbo that always ran like garbage though. I’d say I’m doing better hahah.

Mine was cutting out at around 7900, I didn’t pay attention to the idle but sometimes it is hard to start without a bit of throttle. I will change plugs just to be sure.

Also going to put my stock exhaust back on, I bought a npp one but I’m still having it cut out from time to time. Maybe my sled just hates cans? Lol

The guy I bought the npp from said it ran fine for him, he suggested my issue is with my clutching, exhaust valves or relay. I having checked the other two out, but for Clutching I’m running Bens set up. And adjust my weights for altitude.

Anywho, gotta love sledding haha. Here’s to hoping new plugs will make her sing

 

[catrutt]

View attachment 252436

Think this will ball hone out? Haha new long block picked up and ready to be broken in !

Was this a 2020 khaos?

 

[JustinMan43]

Was this a 2020 khaos?

Yes. Calling the shop tomorrow, think the new motor might be hurt already. 120 km…

 

[catrutt]

Geez I thought they had that problem with the pistons fixed. Sorry for your luck.