850T Coolant Burp Procedure

[turboetech]

Replaced coolant hose from rubbing on jack shaft and can’t get coolant to circulate any one know the procedure to purge the air? I have filled bottle and raised front run til 90 C raised rear and ran til 90 C still won’t circulate coolant tunnel ice cold any advice??

 

[maxwell]

There is two reservoirs remember make sure both are good and engine is above cooler but sounds like you did that

 

[Caper11]

Did Put it on a sled deck ramp? Get the front end way up.

 

[MK4TDI]

Could also try running it with the cap off the coolant bottle, sled ramp is a great idea to get the front end way up.

 

[turboetech]

went out this morning and reservoir was empty added coolant think I got it… hung it off my skid steer front and back with and without cap on coolant tank must have been air locked…thanks everyone hope this helps someone else there should be a procedure to follow without multiple over temps The coolant hose is the long one on right hand side behind recoil cover looks like it hooks from tunnel cooler right side to thermostat housing cheers

 

[RGM]

You have to take the hood off and fill it through the pressure cap. The plastic cap on the overflow res is NOT where you fill it.

 

[turboetech]

10-4 did that….