The big greasy
Active VIP Member
What brands have the flattest paintable fender flares around 4-5 inches high, and stick out minimal. I like the bolt look also but just don't like the look from the rear with them sticking out so far.
3rd gen flat fender flares
- Thread starter The big greasy
- Start date
smokinD
Active VIP Member
I put these on my Ford. Foe the same reasons, I like the flares, but didn't want them too wide.
They were a perfect fit, super easy to install, and marked for all the factory holes (you would have to predrill them though)
Amazon product ASIN B01388SC14
They were a perfect fit, super easy to install, and marked for all the factory holes (you would have to predrill them though)
Amazon product ASIN B01388SC14
- Thread starter
- #4
The big greasy
Active VIP Member
Nice truck, How high did they go up your body, and what did they stick out from the fender?
They match the original fender line, so maybe 2 1/2-3 up, only stick out 1/2"-3/4". Very low profile.
Seriously considering putting a set on the new truck now too.
These were one of the only ones that fit this vintage truck ('09) that didn't cost $600.00 and more, or were special order. They only took 10 days to come in.
Seriously considering putting a set on the new truck now too.
These were one of the only ones that fit this vintage truck ('09) that didn't cost $600.00 and more, or were special order. They only took 10 days to come in.
- Thread starter
- #6
The big greasy
Active VIP Member
They sound good, might go that way if my rust was lower, but it is up 4-4.5 inches up the body. I know the flares might not cover everything, but clean it up a bit. Hoping to find thin and tall ones still.
Similar threads
