3d printer.

[towerrigger]

That PPA-CF is 190 something CAD for .75 KG. I'd have to load it into the program to see what the cost would be per unit.

Rough estimate on cost per using the strong stuff would be $11.00, might have to order a reel and try it out...

 

[Tchetek]

How strong would that be to use?

I’ll try to break one. It’s probably pretty tough with just regular PLA. It’s printed with solid infill.

 

[Tchetek]

Just the normal PLA is pretty strong.

The little lip on the bottom of this stand supports the leverage of the 50 lbs Onewheel no problem and it’s basssically hollow with only 15 % infill.

This used about 1/4 roll of filament. The roll was $10.

They sell these stands online for $60 plus shipping.

 

[towerrigger]

The generic PLA has been holding up on this tool so far. The printer has been running non stop since I unboxed it!

 

[Tchetek]

The generic PLA has been holding up on this tool so far. The printer has been running non stop since I unboxed it!

Where did you find that file? I’ll take one please.

 

[Tchetek]

I think the tabs on the factory male connector is probably the weak link in the situation.