2015 xm T3 spindle bent needs replacing

[drew17]

any recommendation on after market or should I just replace with stock parts?

 

[1100]

I bent one. Also my s mod and a arm. If all you
bent was your spindle, something has to give on an impact. If it was a spindle in your case, there easy to change. I would put another stock one on.

 

[treeboy]

after market ones

 

[Limbo]

Which side spindle do you need, I have a left for sale

 

[butthead1]

Which side spindle do you need, I have a left for sale

how much u wanting for it

 

[fredw]

I had bent the left side, but hit a decent rock at the top of a good pull, was not bent much but was bent.. Can't really blame bad parts

 

[skegpro]

I had bent the left side, but hit a decent rock at the top of a good pull, was not bent much but was bent.. Can't really blame bad parts

Just catch a carbide or did it stop you dead?

 

[fredw]

Carbide grabbed it, flew over the hood, but enough speed the sled stayed in place at the top.. Used it ten rides after till it was replaced

 

[skegpro]

Carbide grabbed it, flew over the hood, but enough speed the sled stayed in place at the top.. Used it ten rides after till it was replaced

Haha been there. I dropped the cardbides and run hardwelds now.

A buddy of mine bent a arm trying to get on a deck with fresh carbides.

Not sure why mountain sleds come with them to tell you the truth.

 

[treeboy]

Haha been there. I dropped the cardbides and run hardwelds now.

A buddy of mine bent a arm trying to get on a deck with fresh carbides.

Not sure why mountain sleds come with them to tell you the truth.

Or you just can grind the carbides down.