2014 starter issue

[Mike270412]

It's almost like it locks up. If I engage the drive by hand and give the primary a sharp twist by hand it will break free. After starting once it's locked up again. Just clicks. Anyone ever had similar issue?

 

[mountianguy]

It's almost like it locks up. If I engage the drive by hand and give the primary a sharp twist by hand it will break free. After starting once it's locked up again. Just clicks. Anyone ever had similar issue?

There was an update on the starters maybe check with the dealer

 

[Go-Vertical]

It's almost like it locks up. If I engage the drive by hand and give the primary a sharp twist by hand it will break free. After starting once it's locked up again. Just clicks. Anyone ever had similar issue?

Update is the shaft from the starter to the clutch with the drive on it. I believe.

 

[Mike270412]

That's where the problem is I believe. Talked to Mark at T&T today ,he said it was the 13 that had issues.This 14 should be ok. I think it's the bushing at the end of that shaft.Tore it all to pieces and then went to work for a couple days.Sure hope I can figure out how to put it all back together.

Update is the shaft from the starter to the clutch with the drive on it. I believe.

 

[Mike270412]

.

 

[FastFarmer]

Could pump some tunes and whistle while you work...

 

[Go-Vertical]

That's where the problem is I believe. Talked to Mark at T&T today ,he said it was the 13 that had issues.This 14 should be ok. I think it's the bushing at the end of that shaft.Tore it all to pieces and then went to work for a couple days.Sure hope I can figure out how to put it all back together.

Mines just spinning at times and kicks out easily. I’m thinking mines on its way out too.