2012 E-Tec in the shop :(

[Julie Mitchell Kryski]

Seems like I am up on my rev limiter every time I hit the throttle...WOT-anyone else having this problem, knocked my clickers down to one and still the same! Any ideas? Otherwise, beautiful sled, a whole new ride for me!!

 

[snopro]

What altitude you running at. You may need to run more pin weight in your TRA.

 

[maxwell]

Yep alt? belt deflection? Stock calibration should be good for clicker 1 at 8000ft so anything below that you will have issues.

Sent from my BlackBerry 9780 using Tapatalk

 

[Modman]

Location looks like Fruitvale, so elevation is 1300 ft in Trail, riding is around 2500-5500 ft in that area generally. Pretty sure takethebounce covered this in another Doo thread, someone else had the same issues. I will try and find the thread.

Here is the link to the thread and the same described issue. If hitting the rev limiter all the time on clicker #1, as snopro said you might have to add some pin weight to bring the RPM down
https://www.snowandmud.com/forum/f14/2011-12-ski-doo-e-tecs-63824.html

 

[cadman22]

I had this issue once and just added more pin weight, no more issues

 

[Julie Mitchell Kryski]

I am running it at about 4000ft. I was on clicker 3, moved down to clicker 1-seems a bit better.

 

[Julie Mitchell Kryski]

Thanks for the link!! I'm on clicker one, and only getting 75-7600 RPM, but seems to be running fine-going to check out that link now-thanks again..

 

[d mills]

Thanks for the link!! I'm on clicker one, and only getting 75-7600 RPM, but seems to be running fine-going to check out that link now-thanks again..

Sounds like #2 should be spot on then......I was on #3 last week at 7000 feet with really heavy wet snow. Its been #1 from 2200 to 8000 ft all winter. Pulling 7800-7900.

 

[Circled-Mistake]

My brother runs a dj clutch kit on his '12 800 (ptek tho) and he is running the same weight as Dj recommends for an 880.... Hes still tinkering...

 

[young-gun]

My brother runs a dj clutch kit on his '12 800 (ptek tho) and he is running the same weight as Dj recommends for an 880.... Hes still tinkering...

Still have to add a bit more! was on #6 last trip.

 

[maxwell]

Need to subtract then

Sent from my BlackBerry 9780 using Tapatalk

 

[Sprint5]

It should be as simple as changing the weights your running.

Sent from my LT15a using Tapatalk

 

[young-gun]

Need to subtract then

Sent from my BlackBerry 9780 using Tapatalk

Are you saying i need to subtract weight? According to DJ best performance is to be had on #3-#4 (best track speed). So i need to add more weight to lower clicker at elevation.

 

[tukernater]

Are you saying i need to subtract weight? According to DJ best performance is to be had on #3-#4 (best track speed). So i need to add more weight to lower clicker at elevation.

Need to take weight away so you can get you clickers down to 3-4 Higher the # higher the Rpm.pull some weight so you can lay the ramp down so it can up shift.