Flip sled on its side and take the bolt out of the clutch.
Poor water in the bolt hole and wrap pipe thread tape on bolt and tighten bolt back in. Hydrologics it off.
sent from A UNKNOWN PLACE IN TEA LAND
Ever seen it happen in real life? I think it would take ALOT of torque to snap the puller I have. That said the water trick does work just fine.Biggest thing is if the puller breaks off inside. Then its a big , $$ job.
sent from A UNKNOWN PLACE IN TEA LAND
Yes I have. The pullers are only made for 125 ish foot lbs.
The bolt is t.qed to 90...
Some clutches have been hot and cold it sticks bad. Had one before I used the bolt method that had 110 flbs on puller and 4 batches of boiling water to pop off.
sent from A UNKNOWN PLACE IN TEA LAND