Engine Block Heater
- Thread starter pcog08
- Start date
slomo
Active VIP Member
it cannot be replaced by a regular cord
medler
I love guns
YA i phoned the dealer on this too ..They said leave it because they had problems with them overheating ,if they are on all the time ,,I had a post on this earlier .And i wanted to cut the end off but the dealer said leave it..
pipes
Active VIP Member
My new company truck is an 09 Chevy with the same block heater cord. The twist to this is, that it is tied into the computer and the computer fouls up when plugged in. My dealer advises me not to plug in my truck until GM get a fix to the problem. Not such a great think with the -40C temps we've been seeing. I asked if I could replace the cord with a standard code and she tells me the computer will come up with a fault code and give me problems. And to think that GM is asking the government for a bail out.
slomo
Active VIP Member
it sucks,im a tech at the dealer and hear this every day,but as soon as a couple of us figure it out in the shop i'll post for you guys
medler
I love guns
So what is the reason for the thermostat?
medler
I love guns
I havent had these problems with the computer ,,,knock on wood
slomo
Active VIP Member
less energy consumption,i guess the peep from ont feel that is the only time we need to use it,thanks greenies
jeremy
Active VIP Member
i never plug in. never.
CRF230LKEL
Active member
The small glue on heaters for your oil pan work awesome.
They heat from the bottom up, and warm your oil nicely, easy starting, and the oil flows quicker on start up.
You can get them at many autoparts stores, or even on ebay.
They heat from the bottom up, and warm your oil nicely, easy starting, and the oil flows quicker on start up.
You can get them at many autoparts stores, or even on ebay.
Jason Shakespeare
New member
Hey guys I'm a newbee and have a 05 GMC and recently when I plug in my truck it pops my GFI breaker. Any ideas? Thanks
johndeereman346
Active VIP Member
start with cord ends to see if they are wired properly if it persists find different wall plug
nathan#19
Active VIP Member
I just had this entire thing happen to me! The cord end got damaged and I replaced it with a regular end. I plug in every night and drive to work where it's plugged in for 12hrs. All is well until the ambient temp comes above -18. Then the ECM sees that the the water temp is above the ambient temp and it's been sitting so they should be the same, so it creates the temp sensor fault code. That turns on the cooling fans, shuts off the A/C and a message on the dash saying so. That is all fine and I can live with that, going Back and forth to work , and only starting it cold, HOWEVER, if you try to restart it after it has warmed up, it will flood because it has gone into de-rate or "limp mode" because it now believes there is a engine temp signal that is incorrect and it's doing everything it can to protect the engine from overheating. Hence the fans on and the extra fuel, which works on a cold engine to start but not a hot one. That is how I understand the issue. Some ppl in Winnipeg are tieing the cord thermostat to a rad hose to make it work correctly down toward -50c. With the thermostat cord end in the grill I never had any trouble in Alberta down to -40c. So long story short, you need the thermostatic cord end or there will be codes and assorted problems.. who knew.
Hope this helps somebody!
Hope this helps somebody!
Last edited:
TROLLCAT
Active VIP Member
disconnect the battery for a minute and that may reset the computer
jjack
Banned
drove tow truck lot of years 0-30 oil and oil pan heater never used block heaters always started.
Similar threads
