Track Wars set to go Feb 26 . They were really slow getting word out this year and i never seen it right away. https://www.facebook.com/photo.php?fbid=2805149972570&set=o.136763679687452&type=1&theater
If you have a sag issue check the front coil over on the skid. Mine lost it,s gas charge and is making the sled sag. I was thinking it was the air shock but it,s not. Just a little FYI .
I use this site to check fit and numbers Alpha Sports - Arctic Cat Snowmobile Catalog . Only way to rebuild them is buy a Spider or find a left over roller kit like ranger did. Course you need special tools and heat to get the spider off.
If your putting that much on you will need a controller anyways so you don,t need to worry about the reflash. I,m surprised it,s not done. Cat would void the warrent on any sleds that didn,t have it done. So most were done early on.
I have an 08 M 1000 with 09 flash and no issues running Y pipe can and Boyesen Rage Cages with out a controller. I wouldn,t do anymore without adding a controller though. I,m sure there is some power to be gained by running a controller and fine tuning it , but also need to reset it all the...
I have a Drift 170 HD and love it. Remote button to stop start, does pictures at set interval if you want. LCD screen on it so no guessing to where it,s aimed. No annoying clicking when you hit bumps like my buds Go Pro. Think they have a fix for that now though. Runs 1080 or 720 and lower. I...
All good points i concur. M series make some room to EASILY get the throttle bodies off! Also i realise it is added weight BUT can we have a real fuel tank .I don,t know of anybody that doesn,t pack extra fuel anyways !! Rather have it in the tank than on the back of the tunnel. Although i,m...
Part# 3007-307
Desc STARTER ASSY,RECOIL
your right i don,t see anything else shown. If you can figure out the thread pitch maybe you can make a piece from a bolt ????+
Hate to tell you to not shop local but
I have a Drift 170 HD and love it. Seems way easeir to use than tha Go pro my buddy has, Built in LCD remote one off. Even think the vid quality is slightly better. I use 2 of the long life batterys and a 32 GB card. One battery will last about 3 hours. Ussually need to switch near the end of...
When you get a new sensor loop it back and tie wrap the wires to the sensor. They break easy. GM durimax sensor 12636945 or......46 number has been upgraded lots. AC numbers are 213 4759 or 213 4778.
NO EGT,s just read it somewhere, Can,t remember where .My dealer told me the same don,t run em like that they tend to run lean. Might be the programming in them. Mine seems fine so far this year , no bog. They do adjust at alt seem to be richer at lower alt. Course they are a Mountain sled LOL ...
Lose track of how many azzhats drive with them on. Even better when they upgrade the bulbs. True Dodge headlights suck i can,t see them past the foglights. So this makes it allright to make the rest of us blind?? So i need to get a set of Lightforce 240 HID,s an ddrive around with them on i...
Oh 1 more option to look at still $200.00 or more . He has them listed on ebay but is a lil strange to deal with. I asked what i would need to carry 2 , 2gallon tanks and what it would cost. He kept directing me to the website and leaving it to me to figure out Lol. Oh well i did eventually...
Yeah i carry the same . Don,t seem to hit it bit still a PITA!! Been looking at other options but OMG all expensive. Was looking at a Trail Tank but a lot of money to carry 1 USG more. Arctic Cat - M-series
Powder Keg is another option. Arctic Cat Fuel Keg AC-200-F
The M 1000,s have a lean spot high rpm low throttle opening. I try not to run mine at speed and hold partial throttle for too long. I have a slight bog at times low alt but it goes away at higher alts. Seems to run rich below 3000 ft. Was thinking it was a break in issue so will watch and see if...
Horsepower and torque too. Short port long port. Short port more torque and low end power Long port high end horsepower. If they are out of adjustment they ussually wont rev or get boggy. Are they clean? What can some guys had issues with certain cans.
Not sure about the STM valves. I eas...