warning light issues

[johnking]

I have been working on a 2009 XP. I've rebuilt the top end and reinstalled it, plugged everything in but the engine light, coolant light, oil light and shutdown engine display all come up and a beeper goes off. Has anybody else ran into this and if so why did you find?? Even with all of the wanrings the engine runs good but does not stay at an idle very well, have to hold the throttle open a little. I have checked over all of the connection and plugs and everything looks good. If anybody has any advise, that would be greatly appreciated.

 

[tex78]

Did u forget to plug in the Dpm valve above the carbs.


If I can recall there are a few plugs that can plug into each other.

Mabe have some flipped.

from my HTC

 

[maxwell]

Also tps sensor on carb

 

[johnking]

ok, thanks guys, i'll check those again.

 

[johnking]

it was doing the same thing when the engine was blown originally, before i took it apart... but from my understanding from the couple of dealers I've talked to, they say it does not have to be rebooted.

 

[tukernater]

it was doing the same thing when the engine was blown originally, before i took it apart... but from my understanding from the couple of dealers I've talked to, they say it does not have to be rebooted.

nope just take and run it up a few times and shut off with dess cord should clear codes(most)

 

[johnking]

nope just take and run it up a few times and shut off with dess cord should clear codes(most)

by "dess cord" do you mean tether cord?