Vanamburg back end for 2007 m8

[git r done]

Just wondering how you guys would recommend this setup and post pics of your sleds with it on. What do you do for a heat exchanger?

 

[gibsons]

I updated my rear end to an 09, then crinkled my rear tunnel. now i installed the VE rear tunnel and love it. I just re used my heat exchanger and it looks fine, just make sure you flatten your cooler if you don't want it hanging out the back.

 

[catrutt]

Sorry no pics but van amberg on my 08 m8 is great super fit and finish.Cooler not a problem at all . My sled has been on it's tail many times. Great bumper for un stuck. I replaced my tail light with led third brake light off a taho very trick and light.

 

[gibsons]

I agree on the bumper, especially if you run with a snow flap, nice and easy to grab onto. Can you put up picks of your setup, i'd like to see your tail light.

 

[catskinner13]

I have this stup on my M7 and don't recommend it. it looks great but doesn't stand up to much abuse. Rolled my sled on a hill and completely folded the whole tail section down about 6". It wasn't what I would consider a bad roll either. Once you kink one of the flat plates on the sides the thing looses all strength.
Can't even carry a full jerry can now without bending it back down again.
It should have a small 90 degree bend on the bottom of the side plates to give it some extra strength.