TRA Clutch button holder tool

[lsone]

Does anyone have some kicking around for doo clutches(xm/xp style primary)... I have all of the tools in a handy carry case that gets lent out... Well it never came back with the button holders. Looking to get my local laser shop to cut me some replacements and would like some measurements.

This is the kit I have... skidoo uses thicker metal and has it tapered to fit the flats in the buttons. This kit just uses thinner material so it doesn't require the taper.

Clutch Tool Kit for for 2008-Current XP/XR/XS/XM - Grip N Rip Racing LLC.

Thanks gang.

 

[Thistledoo]

I have had dozens of clutches apart and never use those 3 holders...works fine

 

[vodoo103]

Does anyone have some kicking around for doo clutches(xm/xp style primary)... I have all of the tools in a handy carry case that gets lent out... Well it never came back with the button holders. Looking to get my local laser shop to cut me some replacements and would like some measurements.

This is the kit I have... skidoo uses thicker metal and has it tapered to fit the flats in the buttons. This kit just uses thinner material so it doesn't require the taper.

Clutch Tool Kit for for 2008-Current XP/XR/XS/XM - Grip N Rip Racing LLC.

Thanks gang.

I have a couple sets of button holders. Not sure where they're from - were in a box of parts I bought.
If you're around Red Deer, I can loan you a set. If you're not around here, I can grab measurements off them tonight if it helps you.

 

[lsone]

I have had dozens of clutches apart and never use those 3 holders...works fine

Different strokes. Ive done it too, but the fact that I once had a complete kit and now I dont annoys the **** out of me so Id like to replace them but not at 30+$ from BRP. I can make them for 5$

 

[lsone]

I have a couple sets of button holders. Not sure where they're from - were in a box of parts I bought.
If you're around Red Deer, I can loan you a set. If you're not around here, I can grab measurements off them tonight if it helps you.

I actually am from red deer but working in edmonton. If you could shoot me some measurements that would be awesome!

 

[vodoo103]

 

[Bernoff]

Wish the drawings in a lot of the manufacturing shops were done by you bud. Nice, clean and easy to read.

 

[vodoo103]

Wish the drawings in a lot of the manufacturing shops were done by you bud. Nice, clean and easy to read.

Some of them are. Never know who you're going to run into on this site.

 

[lsone]

Thanks again vodoo! Got 6 of them cut out, now I'll know who kept them next time! haha