Tools required for clutch kit

[NoBrakes!]

Sorry if its a repost...

Looking at clutch kits.... what special tools are needed to install? press? I'm aware of the puller bolt obviously...

 

[maxwell]

unfortunately for the G4 you pretty much need the entire kit.

1. Primary puller bolt
2. Secondary press (replace bolts in helix after with hex heads)
3. Primary ramp pin puller
4. primary spring cup adapter and press with threaded bolt. The secondary spring cup is now curved so its difficult to separate without the proper tool.

also helps to have the primary holder

next time your in vale i can lend you my kit

 

[Caper11]

Primary puller and holder.
12pt socket
Pin tool but a metric socket head bolt works.
Primary Spring compressor assembly
Secondary spring compressor
Upper gear holder for the chain case. You can use an socket extension


To do it “by the book” this is what you potentially need.

 

[jcjc1]

and joe from ibackshift has a step by step video on it.

 

[Dynamo^Joe]

https://catalogs.recreationsupply.co/snow-2021/
Rec Suppy out of sToon has a good selection.
Page 249, 250, 251
you dont need a grease injector or a c-clip remover. The c-clip i show how to remove it with your index finger and a small scewdriver or seal pick.
https://www.youtube.com/watch?v=ev9FU9LGIy4&t=11s