snowslut
Active member
Has anyone installed the polaris model tether. The wire colors don't match up on my rmk from the manual and don't want to short anything out. I could use some help
Tether help
- Thread starter snowslut
- Start date
Should be a direct plug in to the wiring harness. Mine i mounted the tether between the fuel cap and the switches then just ran the wires a few inches over to the wiring harness which is located under the hood in a velcro wrapped bundle. Inside the bundle is a set of wires with a plug that matches the tether plug.
Mine is a 2013 Pro RMK.
Mine is a 2013 Pro RMK.
nwoprormk
Active member
X2......Remove hood. Valcro Bag on overstruture has a two emty plugs . One says "Accessory". Use the other one. Done
- Thread starter
- #4
snowslut
Active member
Oh really? That easy. Screw the instructions then
- Thread starter
- #5
snowslut
Active member
Yours looked like this ?
- Thread starter
- #7
snowslut
Active member
Thanks for the help.
waynemags
Active VIP Member
what year. if newer should be a two prong plug under hood by the steering post that matches the tether you bought. I just did mine. no cutting
- Thread starter
- #9
snowslut
Active member
It was for a '14 , I used the empty plug inside the Velcro pouch. Works perfect
OnlyPolaris
Active VIP Member
The instructions and the extra two wires on the tether are for the old style sleds where you had to tie the tether into the ignition switch.
- Thread starter
- #12
snowslut
Active member
When you unplug your tether and put it back to stock does it start up? If so maybe it's a faulty connection
Handlebarsnbullets
New member
You should put the washer back in but behind the plastic.
Less chance of it pulling the switch through the plastic in the event the tether freezes on. JMO
Less chance of it pulling the switch through the plastic in the event the tether freezes on. JMO
Similar threads
