Teth-Air
Active VIP Member
Just received my order of offset machined spindles for the Pro. They allow for 1" inset of the ski on each side of the sled to make the RMK 37" narrow. I ran this design all last season and ended up running at 38" as my favorite width and that puts one spacers on either side of the ski. This is great as the ski is not twisting under the spindle as the load is centered on the ski.
The advantages of offset spindles are:
1. No changes to your shocks
2. You maintain FULL travel of your suspension while short a-arms reduce travel
3. You do not need to replace or cut your tie rods
4. You do not need to readjust your suspension or alignment.
5. Super easy installation, 15 to 20 minutes each
6. Returning your sled to stock is really easy
7. Using standard a-arms makes replacements much easier to find and often less expensive
8. EVEN EASIER TO TIP YOUR PRO ON IT'S SIDE
In addition they come with Oilite style bronze bushings so you won't have to try and pry the old plastic ones out of your stock spindles as they will break. It's just too easy
$695/set with 4 bushings, Canadian pricing +gst.
Call or PM me because if you don't they will be gone before the Edmonton show. 403-444-5457
ps, we will be looking at doing these for the AXYS in the future.
Chris
The advantages of offset spindles are:
1. No changes to your shocks
2. You maintain FULL travel of your suspension while short a-arms reduce travel
3. You do not need to replace or cut your tie rods
4. You do not need to readjust your suspension or alignment.
5. Super easy installation, 15 to 20 minutes each
6. Returning your sled to stock is really easy
7. Using standard a-arms makes replacements much easier to find and often less expensive
8. EVEN EASIER TO TIP YOUR PRO ON IT'S SIDE
In addition they come with Oilite style bronze bushings so you won't have to try and pry the old plastic ones out of your stock spindles as they will break. It's just too easy
$695/set with 4 bushings, Canadian pricing +gst.
Call or PM me because if you don't they will be gone before the Edmonton show. 403-444-5457
ps, we will be looking at doing these for the AXYS in the future.
Chris
Attachments
Last edited:
