Riser too tall and ****ty handle bars

[Dmf]

I ended up cutting the ends back a bit so the stock grips would work, the bars are a bit longer. Also I cut a notch in the bar pad foam so you could run the wires like stock was and tucked the plugs under the pad. Ran the wiring down the side of the riser nice and clean

 

[Dmf]

 

[iceman5689]

Found some RSI 8" grips that I will install tonight

Stupid iPhone sideways picture

these just feel to good

 

[AreWeThereYet]

these just feel to good

That's what they are, just in an RSI bag,.. and yes they feel sooooo good lol

 

[AreWeThereYet]

Here is where I put the ground wire, there is a little angled tab bent out that I drilled and attached the original screw to.

This website is ****ed, 2 different computers and an iphone and the picture will not upload straight.

 

[AreWeThereYet]

So I did the switch relocates tonight, pretty easy to do. Just used some leftover heater hose I had for my rad relocate for my quad and a couple hoses clamps, cut my old bent handlebar and bob's your uncle.

And this website is still ****ed up for uploading pictures.

 

[mb1]

Nice work there! I like what you did with the relocates. I was thinking about mounting a bar in there for the kids to hold on to, but this is sweet.


Maverick Max XRS
570 Berg.

 

[mur190]

I cant post pictures but I ended up mounting my cluster inside of the riser with a old piece of handlebar if AreWeThereYet still has the picture I sent to him feel free to toss it up.

 

[AreWeThereYet]

I cant post pictures but I ended up mounting my cluster inside of the riser with a old piece of handlebar if AreWeThereYet still has the picture I sent to him feel free to toss it up.

Here you are, and once again the site never ceases to amaze me haha