PCV Map request

[Pink-Inc]

Anyone out there with a good running map for a M1000 with RKT port and heads with SLP pipe? I already have a good map for the pipe and BDX box but am adding the cylinders and head this year.

 

[Deano670]

Get ahold of Jason at the Racin Station he should most likely have 3 or 4 maps for that set up depending on your elevation.

Deano

 

[0neoldfart]

X2 - The Racin Station (Driggs, Idaho, ph# 208-354-2777) has a bunch of maps for the M1000 - Eric spends a lot of time on the dyno with the M1000, and should be able to help you out.

 

[Pink-Inc]

That's who's map I'm using now for the non ported cylinders. Works pretty good but I've had a hard time getting a hold of him whenever I tried after I bought the map so I wanted to see if anyone else had one. I'll probably just go back to him again

 

[6000fthigh]

running that set up with sw pipe 3 inch track .pcv. biggest thing is getting enough fuel in to it at 7900 and the motor pull hard until it leans have updated fuel system up to the injectors. going to try O-five injectors this year.his porting and head works great . couple the rear suspension after you change out the track out .

 

[Pink-Inc]

running that set up with sw pipe 3 inch track .pcv. biggest thing is getting enough fuel in to it at 7900 and the motor pull hard until it leans have updated fuel system up to the injectors. going to try O-five injectors this year.his porting and head works great . couple the rear suspension after you change out the track out .

I already have the rear skid coupled because of the track. The 3 inch needs it for sure. Where's the O-five injectors come from?

 

[Slamnek]

You could also try brent linderman with arctic edge performance. He has a pile of different map combos.

 

[Pink-Inc]

I never knew Linderman worked with the PCV. I'll give him a shout. Three attempts to get a hold of Eric at RC and still here with no map