I need quick help

[dragn]

hey so my sister kindly removed my broken/ruin throttle cable but she didnt take note of where it goes can i get some one to show me picture or somthing so i no where the cable is suppose to go, so i dont have to worry about it hooking the clutch

 

[Polarblu]

what kinda sled? usually follows the steering post down to the carbs.

 

[RXN]

hey so my sister kindly removed my broken/ruin throttle cable but she didnt take note of where it goes can i get some one to show me picture or somthing so i no where the cable is suppose to go, so i dont have to worry about it hooking the clutch

You let your sister work on your sled????? lol


Years back my sister thought she would help fix the crooked antenia on my 1958 Oldsmobile. (grandpa had installed it crooked when the car was his). but instead of using tools and doing it right, she grabbed close to the base and bent it, which caused it to snap. I could have killed her.

 

[Longhairfreak]

hey so my sister kindly removed my broken/ruin throttle cable but she didnt take note of where it goes can i get some one to show me picture or somthing so i no where the cable is suppose to go, so i dont have to worry about it hooking the clutch

Is she hot?

 

[retiredpop]

You sure it's the throttle cable and not the speedometer cable you're talking about? The speedometer cable is the only one to go down by the clutch.

 

[dragn]

ch!t i mean the speedometer cable sorry but ya i let her or more or less she asked what was wrong i told here and when i got back from a drink and snack brake she had it in her hands and no idea where it went but ya i need to no how the speedometer cable goes. and its a 2002 summit 800

 

[dragn]

what how am i to no s my sister and shes getting married so sorry

 

[dragn]

ok some one please help id like to get it down before i go outwest

 

[snopro]

Run it from the guage pac down, following the wiring harness all the way down where it is tied at the bellpan and then it should run on the inside top of the bellypan back to under the seconday clutch to the fitting on the end of the drive axle on the LH side. There should be retainers along the top of the pan to hold it in place so it doesn't get near the clutches. Where it follows the wiring harness on the underside of the hood make sure it is tie wrapped to the harness good but allow enough slack to open and close the hood properly. Hope that helps!

 

[dragn]

yes it does thanks alot

 

[dragn]

ya sure does thanks man alot