Caper11
Active VIP Member
Check your air box intake tube gasket this is the one that you have to unclip and rotate to get the airbox to slide out of the throttle bodies, I found mine to have a big gap between the plastic tube and the rubber gasket because it had strain on it. Used duct tape to seal the tube for now. Seems the plastic tube is too long and wont seal properly.
Oh yah and don't remove the foam off the airbox it's needed to prevent movement and the rubber bellows on the throttle bodies will unseat if you don't slide the airbox in carefully.
Oh yah and don't remove the foam off the airbox it's needed to prevent movement and the rubber bellows on the throttle bodies will unseat if you don't slide the airbox in carefully.
