Engine temp buttons

[medler]

I am trying to figure out which display buttons need to be pressed to turn on the engine temp feature on a 09 and a 10 m series.
I read it on here once and now I can't find it.


Sent from my phone

 

[CatMan16]

Think I read it was the top two buttons. But you have to have the sno pro gauge I think.

 

[medler]

The 09 is a sno pro and the 10 Is a HCR.
I will try it. Just have it running and press and hold for 5 sec or something ?
Thanks for the reply!


Sent from my phone

 

[Trashy]

Here ya go Med....

All m series cats snow pro ones have built in coolant temp. Need to have gauge on mph and digital display for rpm, hold in on top two buttons or the two small ones never remember what buttons for approx ten seconds when let go there should be a v show up where odometer usually is showing the voltage output of the stator, press button three times I believe there is a 3 space and the temp. 3 157 example. I didn't know this till last year and someone showed me. I am assuming these are the inputs the ECM uses for different sensors. There nothing in the owners manual but you can double check just run with it on, let sled run hot and at approx 176 the coolant should start to flash on the screen letting u know sled is heating up

 

[Trashy]

Here's th thread I found it in

https://www.snowandmud.com/snowmobile-chat-14/2009-c-crossfire-snopro-temp-how-75865.html

 

[medler]

Thanks Doug. I was looking for that thread
Gonna have to try it


Sent from my phone

 

[medler]

Thanks Doug. I was looking for that thread
Gonna have to try it


Sent from my phone

I tried this on the weekend and it works. It's the two left buttons on the cluster. Hold them both down for a bit and it flashes and then press top left one three times and it will show the temp