belt light

[blondie]

I have a 2006 Brute Force 750 I did the reset procedure for the flashing belt light and the light still flashes and it is still in limp mode, what next?

 

[KVF 700]

Carefully try the procedure again.

Also the switch in the belt cover might have been tripped when the belt sh*t the bed, so you might have to take the belt cover back off and just switch it back to it's normal position, then try the reset procedure again

 

[Maxy]

If you had any problems with the belt, the motor would be de-rated and the quad would run at a very low power mode.

 

[m1000snopro]

how do you rest the light? thanks

 

[snowtractor]

buy a chip and it gets rid of it

 

[KVF 700]

To reset, turn ignition off and pull cvt cover. Put switch inside cover back into "on" postion. Remove seat and disconnect the 2 connectors grey and black and reverse them. They are located if sitting on quad in right rear corner. The grey one is not connected to anything, it's just a reset plug. Grey into black and black into grey. On top of the CVT cover is a black connector that goes to the switch inside the cover, disconnect that at this time. With the 2 still reversed and the black one disconnected, turn the key to the on, but don't start the quad. Observe the belt light. When it stops flashing really fast and starts flashing slow, the belt light is reset. Turn key off, and put the 2 connectors under the seat back to their original connectors and plug the connector switch for the CVT back in. Your done.

 

[m1000snopro]

thank you it worked

 

[fat tire]

thank you it worked

Great advice and guidance on this site........nice to be able to ask a question and get the right answer isn't it.....and the price is right too.all was needed was a time estimation in beers!