Anyone know anything about this chip that I just bought off of E-Bay?
It is called powertuning.2009 Performance chip.
1.Locate CTS Sensor Coolant Temperature
2.INSTALL CHIP
when you locate CTS,disconnect battery,ignition turn off
Then unplug two wire connector and plug chip in instead of CTS sensor
Once installed tie back or fasten the wires in a safe place (tape, silicone)
Reconnect the battery.
Start the motor and hold at 2700 rpm's for 1 (one) minute. This will allow
the computer to re-program your ECU.
After holding at 2700 rpm's, let the ATV idle for at least 15-20 minutes;
then turn ATV off and restart before driving.
+25 BHP POWER BOOST CHIP/MOD,GAS SAVER
FOR ALL PETROL ELECTRONIC FUEL INJECTED ATV'S
THIS IS WINTER SPECIAL OFFER.RETAIL PRICE 69$
ATTENTION,THIS IS THE UNIQUE CHIP ON eBAY,REAL CHIP IS INSIDE
IT TAKES ONLY FEW MINUTES TO MAKE YOUR ATV MORE POWERFUL AND FASTER!!!!
POWER BOOST CHIP WORKS BY TELLING THE ECU THAT THE INCOMING AIR IN THE INTAKE SYSTEM IS COLD SO ADVANCES THE INGNITION TO COMPENSATE PRODUCING MUCH MORE POWER!!!!!!!!!!
___________________________________________________
2009 Outty 800R XT (Old Yeller)
ITP off set rims... Aluminum 12"
30" XXL ITP's 2x10's....2x 12's
2" Lift
1.5" Pipe Lift
Dalton Clutch
3000 lbs warn winch
Aluminum skid
Stealth Snorkle
Rad Protector
Mud Guards
Home made 3" mud extenders
Fender Protectors, Foot Pegs
Rear Box with LED lights and passenger heated grips
Front box
Welded on 2" reciever
10,000 lbs plastic coated cable fassened from hitch to back box.....with hook (3' long)
drink holder
mirror
GPS
Any thoughts?
It is called powertuning.2009 Performance chip.
1.Locate CTS Sensor Coolant Temperature
2.INSTALL CHIP
when you locate CTS,disconnect battery,ignition turn off
Then unplug two wire connector and plug chip in instead of CTS sensor
Once installed tie back or fasten the wires in a safe place (tape, silicone)
Reconnect the battery.
Start the motor and hold at 2700 rpm's for 1 (one) minute. This will allow
the computer to re-program your ECU.
After holding at 2700 rpm's, let the ATV idle for at least 15-20 minutes;
then turn ATV off and restart before driving.
+25 BHP POWER BOOST CHIP/MOD,GAS SAVER
FOR ALL PETROL ELECTRONIC FUEL INJECTED ATV'S
THIS IS WINTER SPECIAL OFFER.RETAIL PRICE 69$
ATTENTION,THIS IS THE UNIQUE CHIP ON eBAY,REAL CHIP IS INSIDE
IT TAKES ONLY FEW MINUTES TO MAKE YOUR ATV MORE POWERFUL AND FASTER!!!!
POWER BOOST CHIP WORKS BY TELLING THE ECU THAT THE INCOMING AIR IN THE INTAKE SYSTEM IS COLD SO ADVANCES THE INGNITION TO COMPENSATE PRODUCING MUCH MORE POWER!!!!!!!!!!
___________________________________________________
2009 Outty 800R XT (Old Yeller)
ITP off set rims... Aluminum 12"
30" XXL ITP's 2x10's....2x 12's
2" Lift
1.5" Pipe Lift
Dalton Clutch
3000 lbs warn winch
Aluminum skid
Stealth Snorkle
Rad Protector
Mud Guards
Home made 3" mud extenders
Fender Protectors, Foot Pegs
Rear Box with LED lights and passenger heated grips
Front box
Welded on 2" reciever
10,000 lbs plastic coated cable fassened from hitch to back box.....with hook (3' long)
drink holder
mirror
GPS
Any thoughts?
Last edited: