Search results

Is it possible for my crankseal to be bad as the clutch side is the leanest

I have regular in it now will that cause it to be all different?

I have a ultra 680 with slp pipes on it, I put in ultra spx needles. My jet sizes go 400, 380, 400. The carbs are pretty close to being perfect for syncing them. I have the e-clip on the middle of the spx needle. What should I do? Do the needles have to be on the same e-clip across all 3?

Pulled apart my carbs they are clean and don't have the slp jets and needles in them!!!!! I just emailed slp to see if they can give me some Part numbers I could order to match up pretty close to what is needed

Thanks guys looks like ill be doing that this weekend

I am wondering what are your thoughts on sway bar removal? I removed mine on my 2004 MXZ 800 and it handled 100x better. The fun factor went up and I could carve easier and side hill a lot easier. Will it be the same case with the old wedge chasis? I have to replace a sway bar bushing but if...

I love the clearance in the rear, where can I find a set of drop brackets like that

Thanks, that is a pretty cool looking sled

Thanks, I did the exhaust joints today ill run it tomorrow evening to see if there is any more leaks. Next task is to make sure it's jetted properly but I'm not sure if ill tackle that one myself I know a mechanic who will do it for me. I rerouted the lines to the bars today too so tomorrow...

It is coming from the exhaust I just stuck paper towel under the joint and let the sled warm up for a bit and the paper towel turned black

This is what mine looks currently, skis are from a rev they are 7 " wide, and I just had the seat done

Thanks for the tip, I have 1.25 lug but wouldn't mind going to 1.75 if one came up for the right price

Thanks, mine is the SKS, ill look into gearing I would like to have torque lol

Wow thank you I degreased my engine today and ran it a bit and it looks like it is coming from the pipes, I will seal that up and run it a little bit and see if that takes care of the issue what do you recommend to seal it up? Orange hi temp silicone?

That's a ton of help!

Can I replace the base gaskets with the engine still in the sled or is it best to pull it? The repair manual only shows if it is pulled from the sled

Thank you, I just found a free download that worked

I am looking for a repair manual or a shop manual download for my 1996 ultra 680. Does anyone know a link or reputable site I could download one from?

That's what I kind of figured I guess the earlier models had that issue with the cylinder base gasket

I just bought this ultra 680 for a good price. I had it idling for a bit warming it up and I drove it forward a bit and noticed a lot of black in the snow where the exhaust was. It has SLP triple pipes. Also I was looking near the exhaust head at the base of the cylinders it appears to be...