Search results

No I did not... should I try this

Starts runs for about a minute leans out and dies ??? Runs like crap wont pull clean... afr all over the place... Where do I start !!! Changed the stator the end of last season. Changed the Ecu, ccu, wireing harnes, injectors, restor in place of the pip sensor, everything from handel bars...

Got the tps sensor tested and it was fine.. set throttel bodys all back to factory settings.... Bought a new wireing harnis and installed that and same thing... starts runs for about a minute leans out and dies... everything has been changed except the coils and the motor... ****in done with...

When the wire sheared off did the servo still work... I will have to check thoe wires also...

Was not the injectors.. injectors ohm at 12, 2 cold... wirs all good pin to plug.. But got thinking about the tps again and when I got my throttel bodys back from shain I threw them on an ran them had problems right away.. pulled it apart finding one bolt missing and one bearly holding the tps...

Have to injectors to try out going in right now... how would I check the ohm resistance... just between the two wirs or

That is what I am thinking... there is 7000 miles on the stock injectors.. 5000 mils with the slp kit and about 2000 boost miles... plugs ar a little diferent color from side to side

Have thought about the tps sensor... I will have to take it to the dealer to get it checked out cnelson6... and running shains high volume pump...

Had checked the wiring harnes everything looks good... fuel pump seams to be working properly With shains relay tied into acc power to run the big pump Tryed running the pump on the stock wireing and no difference ... tryed another stator last year...headlights hand and thum warners tail light...

Fuel presure at 41 psi and increases properly per lb of boost... tryed going up or down with the presure and did not fix the problem

The motor has 1000 miles on it... I did try spraying eather around the crank seal by the clutch earlyer today and it did not rev up ..

Running shain race gas kit 3071 with the boost it box At the end of last year is started to act funny and would not pull clean and would run reallly lean and shut off at idle.. figuring it was the atitude box.. so I jamed it in the corrner of the shop for the rest of the year untill I put the...

Anyone have any video footage of the m1000 rippin with the boost it box ?

Ok smokin dave looking forward to hearing back from you...

Plan on running 10-12lbs for the most part.. shain stangers full race gas kit... I talked to niel from boost it today and he said he has a map that will work for a starting point... something I have found out today there is a 800 map installed on the box from TSS ? Not sure if this will...

Just installed the boost-it box on my 08 race gas twisted m1000... looking to talk to someone about values... I am new on here.. any help would be highly appreciate..