Search results

You also need to know what update you are running in your as the maps well be different for different updates, I'm running one of Jim's map slightly tweaked, been working good.

How's the fuel been in mcbride? Is there still only the one gas station?

Compression testers seem to vary quite a bit I have three different ones and the one that reads the highest is a cheap-o that I bought from princess auto. The other two are snap-on and read 20 pounds different! Best to monitor with a single gauge.

I'm not close to edmonton sorry

Mine went out last year. I was looking a where they have it mounted to and it is rubber mounted so there is no path back to ground! I added a ground strap back to the chassis and has been good so far.

1997 700 RMK was a great sled it did have scored pistons after the first 200miles and I froze up a carb later on and took out a piston and jug. sled had 4400 miles on it when I sold it. 2001 800 RMK Best sled I've ever owned! I did the complete engine at 4000 miles because it had 4000miles...

I did my 09 rmk it's not as big of deal as you think. Most unplug below the riser by the steering post and the worst is the left side handle bar controls but after you unscrew it from the bars there is two plug ins that well come out. Don't pull the switches apart like I did!

Who actually carries there pink insurance card with them? I tried in the past but always ends up going to mush from getting wet(even in a bag). I been carrying mine in the truck. If I can't produce my card is that the same as no insurance?

I did the same thing when I had my 97 700. I was able to straighten it out and I also added some aluminum channel under the running board for extra support it just looked like the older ones with the heat exchanger under the running board.

If your looking for maps Jim at dynotech has some. I'm thinking you meant So what's THE point of your post!

I thought about that but it would take up so much room in the box!

I have a few from dynotechresearch but he puts alot of effert into developing them so I won't share them. Check out his website though.

Seams to be a issue with the older sled, dad had the same issue!

I've seen a ford with a marathon bolted to the floor roll over with two quads on the deck and the deck broke off on the first roll leaving the frame of the deck behind it the box. The second roll smashed the cab, for this reason I added a belly bar to mine just don't over tighten it. I should of...

parting out 1980 John Deere Liquifire 440 L/C - Grande Prairie Snowmobiles For Sale - Kijiji Grande Prairie Canada.

I had my 97 calibrated at my polaris dealer so yes you can!

My 09 went out in jan same kind of think but mine would still run to about 6000-6500 before it would cut out! Common problem with these. The good think is it failed to low voltage and saved the computer, some fail high and take it out.

I got mine from the dealer but I can't remember the p/n.

I installed the same springs and it is a big difference I'm 250lbs with out gear and I keep it on the softest setting and it hardly ever bottoms out! the one thing I did notice is that it doesn't handle quite as well in the powder but I should be able to adjust the limiter straps on the front a...

I've updated the link!