Search results

just trace the wires back to the little black wiring harness clip. undo it. then u have to open the back side of the harness and use a scratch ale or something pointy to hold open a tiny clip inside the harness so you can pull the two pins/wires out

thats sucks. hope all works out with insurance and u like ur new sled even better!

Have never heard of anyone that put one on and didn't like it...

i would pull the clutch appart and check the ramps and rollers. if there wore out and the rollers are catching on the ramps what your describing could happen

Ya the pins are really east to bend if ur not carefull

pop ur clutch off and use a 3mm allen wrench to take the set screws "weights" out of your rollers and go from there.

I would have to say epic is 3 or more feet of fresh :D

Agreed talk to ur dealer

Awesome!

This is for a friend New top end prob 600km ago in an 05 Rev Adrenaline. Just checked the plugs last ride and they are very black. You dont really hear of anyone changing jets anymore? so is there a air/fuel mixture screw a guy can adjust or is something screwing up with the...

If your putting a longer track on you will need new drivers and take your time when u pull the driveshaft out so you dont damage the chaincase bearing! Good luck!

I have a Jaws can right now and i like it but would prob buy a stainless mbrp if i were to buy a new one

120 is good. Do a cold test with the throttle held wide open with a zip tie or elastic and give it 6 good pulls. As for side to side more than 5psi diff you should be watching it to see if it gets worse. Good luck

I actually bought myn in cross iron mills mall at a kiosk in the middle of the mall. It's the go pro hd and it came with like 12 diff attachments and the rechargeable lithium battery and a bunch of cords. i think i payed 365ish including tax. i then went to future shop and bought a 32gb SD card...

You twisted your Nun :(

I agree with jbb. I had two hundred thousands machined off my head to to raise the compression but still be able to run premium pump gas.:d

Ya you dont need the tool. just loosen off the chain a bit and then take out the bolt and then grab a 1/2" 3/8drive socket and at least a 8" extension and a 1" 1/2drive deep socket. Slide the 1" socket over the 3/8"drive extension and then put the 1/2" socket on the end of the extension. This...

It was good. I little cold with the wind if u stopped for too long. Decent base setting up but its on a weak layer so need some warmth to make it more stable. Broke trail in prob a little under a foot of fresh up the bob sled chute and played the rest of the day on the hills up there

Inn on the Border Weather Report: Corbin Turn Off @ Hwy #3: Nov 25/10

Hey guys just wondering what the conditions are like in corbin. Will be out there sat and would like to go into the rolling hills if they have enough snow? We rode Barns two weekends ago and it was decent but they needed prob 2-3 more feet to cover up all the land mines. Thanks