bradtothebone
Active member
All, I am looking at upgrading the shocks on my 2020.5.
Looking at Fox floats woth the evol chamber or else coil overs
i have zero experience with the floats- previously had raptors and was super happy with them. Thought is
go down the fox
path as we have local dealers here.
the floats seem to save weight, and are super adjustable. The coil
overs are adjustable as well, just looking for feedback - as the last people that had floats i knew were back many years. Back at the m1000 cat era.
comments?
i have read damn near every thread, fox/Elka/Enzo/raptor ace/toms. Looking for current feedback.
Additional question: had a buddy run over a small tree stump -
totally bent both rear skid wheels, pulled a bearing almost out, ripped
the circlip out of the groove - the as a beast to fix. Took a torch and melted the wheels a little at a
time and straightened them with a pair of channel locks....enough tomlimp
out. Was so bad each wheel would walk on one side of the the trqck
nubs over into the track window and back. 2 hours of melting plastic to get it somewhat rideable.
q: would the wheels kit from mountain tek - which couples the wheels together have helped, should a guy go and put the 9 or 10 inch wheel and axle assembly on
Again, comments please! Looking for input.
thanks!
Looking at Fox floats woth the evol chamber or else coil overs
i have zero experience with the floats- previously had raptors and was super happy with them. Thought is
go down the fox
path as we have local dealers here.
the floats seem to save weight, and are super adjustable. The coil
overs are adjustable as well, just looking for feedback - as the last people that had floats i knew were back many years. Back at the m1000 cat era.
comments?
i have read damn near every thread, fox/Elka/Enzo/raptor ace/toms. Looking for current feedback.
Additional question: had a buddy run over a small tree stump -
totally bent both rear skid wheels, pulled a bearing almost out, ripped
the circlip out of the groove - the as a beast to fix. Took a torch and melted the wheels a little at a
time and straightened them with a pair of channel locks....enough tomlimp
out. Was so bad each wheel would walk on one side of the the trqck
nubs over into the track window and back. 2 hours of melting plastic to get it somewhat rideable.
q: would the wheels kit from mountain tek - which couples the wheels together have helped, should a guy go and put the 9 or 10 inch wheel and axle assembly on
Again, comments please! Looking for input.
thanks!
Last edited: