Arctic cat primary torque spec

Slammer85

Active member
Joined
Dec 19, 2009
Messages
86
Reaction score
0
Location
Fort Saskatchewan,AB
What is the primary clutch supposed to be torqued to when being put back on the sled? Or do u just use an impact and run it on? Thanks
 

macronut

Active VIP Member
Joined
Feb 14, 2007
Messages
1,720
Reaction score
589
Location
AB
What is the primary clutch supposed to be torqued to when being put back on the sled? Or do u just use an impact and run it on? Thanks

Hey Slammer85! My 2008 M1000 manual states that the torque setting for this is : "Tighten to 32 ft-lb."


DriveClutchTorqueSpecs.jpg
 

Rucky

Active VIP Member
Joined
Feb 14, 2007
Messages
2,060
Reaction score
70
Location
Fort Saskatchewan, AB
Hey Slammer85! My 2008 M1000 manual states that the torque setting for this is : "Tighten to 32 ft-lb."


DriveClutchTorqueSpecs.jpg

That'd be the secondary.

For my 2010 M8 it's 55 ft. lbs if I remember correct. Also after running the sled you may want to check the torque again.
 

macronut

Active VIP Member
Joined
Feb 14, 2007
Messages
1,720
Reaction score
589
Location
AB
That'd be the secondary.

For my 2010 M8 it's 55 ft. lbs if I remember correct. Also after running the sled you may want to check the torque again.

You are correct :) ch!t wrong pic lol

Here is the correct shot for the Primary:
PRIMARYCLUTCHTORQUESPECS.jpg
 

ZRrrr

Active VIP Member
Joined
Dec 6, 2006
Messages
3,338
Reaction score
3,495
Location
In my head
...and don't forget to spin it then retorque. Even a couple O' times.
 
Top Bottom