https://www.facebook.com/groups/374249432997598/
Jan 27, 2018 - Edson Alberta
Facebook page will be updated as we work out the details, but the ride will similar to last years ride. Share the Facebook page!
We had to make a few changes to this ride. We will now be using the north trail from the North Staging Area and going to Peppers Warm Up Shelter. This ride will be a little shorter than the south trail. Here is the update poster.
For those that like riding their vintage stuff, there is a couple drag racing events coming up.
Obed ice drags Feb 9 & 10: They will run vintage sleds if there is enough to make up classes and they have bracket racing: A 40 year old single lunger could beat out the new 1000cc open mods and go...
3D Racing out of Hinton Alberta is trying to bring back ice drags into Alberta:
Some of the big open mods should be 130mph+ right at or under 5 secs.
440, 600, 800, 1000cc in stock, pro stock and open mod classes
Dedicated test and tune lanes, and zamboni prepped race lanes
We are showing...
Not sure if I understand this: You moved the camper battery negative to the truck? If so, you need to add another wire from the camper battery to whereever it was before you moved it or ground the camper electrical system to the truck.
If you added a ground from the camper battery then you...
Assuming you started with a clean carb....
If the chop was at WOT change the main jet; one size larger
If at half throttle lift the needle (drop the clip) one notch
Beware that iridium plugs take a longer run before the chop to get a good read.
Onan has been the most used built-in RV generators and switch gear for years. Recently they have been re-branded as Cummins/Onan.
Typically they are a PIA to service because of the RV manufacturers place them in the most difficult places on the RV. Once out of the RV they are easy to...
Check the power distribution box; finned box under the front rack. Everything electrical runs through this box.
BTW, fuses are hard to find because this box contains all the self re-setting breakers, relays, etc.
Top speed is dependent on tire size and weight; 90 -95 (matbe) with factory size and weight tires. My '98 is 100 tops with vampire tires but there is some work done to it.
If you break a rear u-joint, replace the wheel bearing on the same side. I've broken so many rear u-joints that I carry...
Frequency of the tick? Crank speed, valve train speed, transmission speed or random/unregular?
You should be able to isolate the problem to with a couple of inches with a steathescope or the long screwdriver to the ear trick. Without it being narrowed down a bit more it could be anything from...
Have you tried a new spark plug. The plug may spark when checked out of the hole but fail under compression
Check the valve lash. Tight intake valve will cause a rich condition and low starting compression
Check the flywheel key. Broken key may get you spark but at the wrong time.
Water...